FlowsBook a callSign inCreate free accountSign up
Site selection and expansion

Care home site selection: older residents, a hospital close by and roads families use

Care home site selection weighs the over-60 share around a plot, the nearest hospital, how families and staff get there, and the homes already serving the area.

Part of the guide AI employee for site selection

By the xMap team · · 6 min read

Care home site selection comes down to three questions: are there enough older people living within a short drive, is a hospital close enough for emergencies and appointments, and can families and staff reach the home easily by road. A fourth question decides whether the first three are worth much: how many care homes, retirement homes and assisted living sites already serve the same people. Where population figures exist, the over-60 share inside a drive area is the clearest single signal to start from.

This article is for care operators, healthcare property developers and investors in senior living. It sets out the questions in order, explains where the data exists and where it does not, walks through a made-up comparison of two plots near Lyon, lists the mistakes that cause a home to fill slowly, and shows how an AI employee can keep a regional shortlist up to date.

Who chooses a care home, and from where

A care home is rarely chosen by the resident alone. A son or daughter usually leads the search, and they look for a home close to where they live, so they can visit often. That pulls the real catchment in two directions: the older people who live nearby, and the adult children who live in the same town or a short drive away. A plot in a retirement area far from working-age families can struggle; a plot in a mixed suburb with a clear older population often does well.

Staff are the other half. Care workers work shifts, often early and late, and many travel by bus or on foot. A home that is pleasant but hard to reach without a car finds recruiting slow.

Five questions, in order

  1. How many older people live within a 15 minute drive? The Demographics block counts residents in nine age groups and gives the number and share aged 60 and over inside an area. Population figures exist in some countries only, among them France, Canada, India, Thailand, Egypt and Australia, and not the United Kingdom or the United States. Elsewhere, bring your own census figures in as a table.
  2. How far is the nearest hospital? Nearby places finds hospitals around each plot with their distance. Look for one with an emergency department within a short drive, and note general practices and pharmacies close by for routine care.
  3. Can families and staff get there? Draw a Travel area around the plot by car and another on foot. The car area shows which towns relatives can visit from; the walking area shows whether staff can reach it from homes and bus stops. Travel area follows real roads but does not know rush hour.
  4. Who already serves the area? Count nursing homes, retirement homes and senior and assisted living sites inside the drive area. Note how they are rated and how many reviews they have; families read those reviews closely.
  5. Is the street right for the home? Live road speeds from Traffic Flow at visiting hours show whether the approach is calm or jammed. Quiet surroundings matter for residents; an easy approach matters for ambulances and visitors.

Reading the over-60 figure properly

A high share of older residents is not enough on its own. A small village where half the residents are over 60 may hold fewer older people in total than a dense city district where the share is a fifth. Read the count and the share together, and look at the older bands within it: the 80 and over group is the one most likely to need residential care soon, while people in their sixties may be a market for retirement housing instead.

A worked example, made up

Say an operator is comparing two plots on the edge of Lyon. Plot North sits in a suburb of houses and small apartment blocks. Plot East is a former office site beside a business park.

Within a 15 minute drive, Plot North has more residents aged 80 and over, and a higher share aged 60 and over, than Plot East. A hospital with an emergency department is eight minutes away, and a bus stop is a short walk from the gate. Two care homes already operate in the area; one is well rated with many reviews, the other is rated much lower. Plot East has a newer road and is cheaper, but its walking area holds almost no homes, and the nearest hospital is further out.

The operator shortlists Plot North and plans to compete on quality against the weaker home nearby. All of these details are invented to show how the checks fit together.

Mistakes that make a home fill slowly

  • Following the share alone. A high over-60 share in a thinly populated area can mean few residents in total.
  • Forgetting the visitors. A home far from where families live gets fewer enquiries, however good the building.
  • Ignoring staff travel. No bus stop or walking route can make night shifts hard to fill.
  • Counting rivals without reading them. A poorly rated home nearby is an opening; a new, well-rated one is a real competitor.
  • Assuming data exists everywhere. In countries without population figures, plan on your own census tables from the start.

An AI employee that scores plots for you

An AI employee can run the same five questions over every plot your land team brings in, and again each month as new ones arrive. For the general approach, see AI employees for site selection. A flow for care homes:

  1. New rows: starts whenever the land team adds a plot to a table in My data.
  2. Travel area: 15 minutes by car around each plot.
  3. Demographics: residents by age group in each area.
  4. Nearby places: hospitals, then nursing homes and retirement homes, each with distance and rating.
  5. xMap LLM: a score from 0 to 100 using your own rules, such as the 80 and over count, the hospital distance and the rivals' ratings, with a short reason.
  6. Approval, then Email: the plot is sent to the investment committee once the regional manager agrees.

What arrives is one message per new plot: its older population, the nearest hospital, the homes already there with their ratings, a score and why. The Where seniors need home care most template counts older residents by area and is a good base; Neighbourhoods far from a hospital shows the hospital side.

Questions

What age group matters most for a care home?

People aged 80 and over are the most likely to need residential care soon. Demographics gives nine age groups, so you can look at that band as well as the wider 60 and over figure.

Can I get population figures for a site in the United Kingdom or the United States?

Not from Demographics today; those countries are not covered. Load your own census or local authority figures into My data and the flow uses them the same way.

How close should a care home be to a hospital?

There is no single rule, but operators usually want an emergency department within a short drive. Nearby places gives the distance to each hospital so you can set your own limit.

How do I find the care homes already near a plot?

Use Nearby places with the types nursing home, retirement home and senior and assisted living. Each result comes with its distance, rating and number of reviews.

Templates that do this

Read next

More on site selection and expansion · Every article · Templates

Put it to work

An AI employee in xMap Flows does this on live data, on its own timetable. Start from a template or describe it in plain words.