FlowsBook a callSign inCreate free accountSign up
Population and demographics

Population near EV charging site candidates: who lives within a walk of the plug

Kerbside and neighbourhood chargers live on the residents who can walk to them. How to count them by age, set them against chargers already there, and rank the sites.

Part of the guide Location intelligence automation

By the xMap team · · 5 min read

To judge the population near EV charging site candidates, count the residents who live within a five to ten minute walk of each one (roughly 400 to 800 metres), keep the adult age groups, and set that figure beside the number of public chargers already in the same walk. A site with many adults in walking distance and few chargers is the one where people without a driveway will plug in overnight and walk home.

This is written for charge point operators, councils planning kerbside chargers, landlords of apartment blocks and car parks, and energy retailers adding neighbourhood charging. It covers why walking distance matters more than driving distance for this kind of charger, which figures to pull, a worked example on made-up sites, the usual mistakes, and a flow that ranks every candidate for you.

Why the walk decides a neighbourhood charger

A rapid charger on a motorway serves people passing through; nobody lives next to it. A slow or medium charger in a residential street is different. Its regular users park, plug in for the night or for a few hours, and walk back to their flat. If home is twenty minutes away on foot, they will not use it. So the useful catchment of a neighbourhood charger is a walk, not a drive, and the people inside that walk are the market.

Two kinds of street produce the most overnight demand: dense blocks of flats where few homes have off-street parking, and older terraced streets where cars line the kerb. Both show up as high residents per square kilometre. A detached suburb with garages shows lower density, and most of its drivers charge at home.

The figures to pull for each candidate

  • Residents within the walk, from a population grid: everyone living inside a 500 metre or 1 kilometre circle, or inside a walking area drawn on the real streets.
  • Adults aged 20 to 59 and 60 and over: children do not drive, so a street full of families counts for less than its headline total.
  • Residents per square kilometre: a rough stand-in for flats without parking.
  • Public chargers already within the walk, with how many are fast and how far the nearest one is.
  • Residents per charger, worked out from the two: the clearest single signal of an under-served street.

A worked example with made-up sites

Say an operator in Lyon has four candidate kerbside spots and a budget for two. The numbers below are invented to show the method, not real counts.

SiteAdults within 500 mPeople per km2Chargers within 500 mAdults per charger
A, old town street6,10011,80041,525
B, new flats by the river5,30010,20005,300
C, suburban square2,2003,90012,200
D, next to a supermarket3,8006,7006633

Invented figures for four sites, for illustration only.

Site A has the most adults but already four chargers. Site B has slightly fewer adults and none at all, so it ranks first on adults per charger. Site D is busy with chargers already, which the supermarket probably added for shoppers. On this evidence the operator would shortlist B and C, then send someone to check kerb space and the local grid connection before committing.

Mistakes that send chargers to the wrong street

  • Using a drive-time catchment. A 10-minute drive in a city holds tens of thousands of people and makes every site look the same. Walking distance separates them.
  • Counting all residents. Leave the under-20s out, or at least look at them apart, before you compare sites.
  • Ignoring chargers already there. A dense street that already has several chargers within a few minutes is served; the next one adds little.
  • Treating density as car ownership. Dense centres often have fewer cars per home. Pair the population count with your own registration or customer data where you have it.
  • Comparing across countries without checking coverage. A candidate in a country the grid does not cover comes back with no residents, which is not the same as nobody living there.

Ranking the sites with an AI employee

In xMap Flows a flow is an AI employee: blocks in a row that run on their own and report to you. For this job it reads your candidate list, counts people and chargers around each, works out the ratio and emails the ranking. The general method sits in the guide to AI employees for site selection.

  1. My data: upload the candidate sites as a table with a name, latitude and longitude for each (My data).
  2. Travel area: draw a 5 or 10 minute walking area around each site on the real streets (Travel area), or skip it and use a plain circle.
  3. Demographics: residents in each walking area or within 500 m, with the nine age groups and people per km2 (Demographics).
  4. EV charging: the public chargers within the same distance of each site, how many are fast and the nearest one (EV charging).
  5. Calculated field: a line such as adults_per_charger = if(ev_stations > 0, round(adults_20_59 / ev_stations), adults_20_59).
  6. Sort and limit: the highest ratio first, keep the top ten.
  7. Email: the ranked list lands in your inbox with a map of the sites.

What arrives is one row per candidate: its residents, its adults, its density, the chargers already in walking distance and the ratio that ranks it. Run it once for a planning round, or monthly so that chargers opened by competitors change the ranking without anyone redoing the sums. The template Fast charger sites where drivers already stop is a good start for the busier, rapid end of the network, and Busy shopping places with the fewest EV chargers covers destination charging. More flows for the sector are on the energy and EV page.

Questions

How far will people walk to an EV charger near home?

There is no fixed rule, but planners usually work with a five to ten minute walk, about 400 to 800 metres. Test both ends and see whether the ranking of your sites changes.

Can I see how many electric cars are registered near a site?

Not from xMap's data. The population grid counts residents by age, and the EV charging block lists chargers. Add your own registration or customer data with My data if you have it.

Does it work in the United Kingdom or the United States?

The charger counts do, but population figures are not available there yet. In those countries rank by chargers, density of flats from your own data, and how busy the area is.

What is a good number of residents per charger?

It depends on your charger type and local car ownership. Use the ratio to compare your own candidates with each other rather than against an outside benchmark.

Templates that do this

Read next

More on population and demographics · Every article · Templates

Put it to work

An AI employee in xMap Flows does this on live data, on its own timetable. Start from a template or describe it in plain words.